Coastal Tf Black From 2,5 Lt

Hard matrix antifouling of certain reliability with a high percentage of cuprous oxide and special substances, ideal for use in any type of sea. It offers a safe protection on the hull, after applying an appropriate primer. It is applied on wooden, iron and fiberglass hulls (not suitable for aluminum hulls). Also suitable for speeds above 30 knots.

SUBSTRATE PREPARATION AND APPLICATION CYCLE

New iron hulls. Apply a coat of EPOFOND AM-9 to iron sandblasted to grade 2.5, leaving it to dry for 12-24 hours. (If sandblasting is not possible, it is advisable to mechanically restore the iron to new condition; clean the surface and apply 1 coat of EVIOX CROMOMINIO leaving it to dry for 8-12 hours.) Then apply 2 coats of SOLVER PRIMER spaced out 24 hours between them . Overpaint with 2 coats of COSTIERA TF antifouling at least 8 hours apart.

New wooden hulls. Apply a coat of EVIOX CROMOMINIO and let it dry for 8-12 hours. Apply 2 coats of SOLVER PRIMER 24 hours apart, then 2 coats of COSTIERA TF Antifouling at least 8 hours apart.

Fairings already painted. If the old antifouling is in good condition and well anchored, it will be sufficient to apply one or two coats of SOLVER PRIMER, before overcoating with 2 coats of COSTIERA TF, leaving at least 8 hours between coats.

Fiberglass and Plastic. Degrease with detergents and water and rinse. Sand lightly with fine abrasive papers and dust. Apply a coat of POLIFIBER PRIMER and after 24 hours sand with fine abrasive paper. Then apply 2 coats of COSTIERA TF at least 8 hours apart.

nb as an alternative to POLIFIBER it is possible to use EPOFOND AM9 in the same conditions.

Recommendations. The maximum period for putting the antifouling into service, after the application of the last coat, is 1 month; with the top-of-the-range copper oxide-based products and subject to agreement with our technical personnel, the same can extend up to 3 months, provided that the hull is protected from humidity, rain, or atmospheric agents, with plastic or similar material.

Color. The color of the antifouling after immersion may undergo a slight variation. Small differences in color may occur between different production batches: if necessary, mix them before application.

Remarks. The values ​​indicated in this technical data sheet may undergo slight variations from one production to another. The applied product must not be placed in contact with water, chemical products or subjected to mechanical stress before complete cross-linking. The thicknesses of the wet film are intended for the undiluted product. With dilution, this value will increase. The above information is the result of accurate laboratory tests and practical experiences, however, given that the product is mainly used outside the manufacturer's control, the same can only guarantee its continuous quality. The information contained in this fact sheet may be subject to revision by the Company. For clarifications, updates or further information, it is advisable to contact the manufacturer directly. This document cancels and replaces any previous one.